The best low-profile tri-mode mechanical keyboard? nuphy air75 aluminum alloy translucent shell

The keyboard in my hand, at a glance, feels like the one on a notebook, the keycap is not high, the keys are compact, and the layout is square.

This shape reminds me of early lenovo and thinkpad

Because ordinary mechanical keyboards are big, heavy and thick, if you want to choose a thin, small and light one, it is difficult to find the right one.

Then I found this low-axis one, and I built one, nuphy air75 three-mode keyboard

A low-axis mechanical keyboard with 75 layouts and 84 keys is basically half the height of a normal mechanical keyboard, with a height of 16mm and a length of 31cm

The middle frame is made of aluminum alloy. There is a light bar on each side of the front of the keyboard. The rear side is for switching between windos and mac, bluetooth and 2.4, and wired three-mode switching. The typec port is not plugged into the 2.4 receiver because of the size of the body. Into the fuselage, it's a bit unnatural

The back cover is ABS translucent, when the RGB lighting effect is turned on, the back cover is also transparent

With four long foot pads and magnetic foot supports, it is not too high.

In the middle is a mirrored metal nameplate, which can be used as a mirror

When you are typing, you suddenly want to shave, pop acne on your face, put on makeup, etc., it is still enough, needless to say the purpose of the mirror,

The overall texture is good, the foundation is very pleasing to the eye

The key cap is PBT, which is frosted like the shell, but it feels smoother. I can’t tell its up and down except for the characters, so when I look at the direction keys, I just put it on.

It comes with keycaps for windows and mac, and the official driver can also change the key position. This keycap is also opaque, but the bottom of this keyboard is still very good-looking. Change to a short chocolate keycap that is light-transmitting. It should improve the appearance. Quality improvement, of course, regular height keycaps can also be used for replacement

In addition, it also comes with three Jiadalong green switches, tea switches, and red switches. I chose the red switch, and the key stroke is very short. Except for the brittle feeling between the big keys, the overall sound is more wooden. click sound,

I might prefer the red switch, but the short switch may feel better than the green switch, because there is a segmented feedback and a more mechanical feel, but the sound is too obvious.

Except for the space bar, its shaft is very difficult to pull out. I almost thought it was welded, and I didn't dare to pull it out at first, but it supports hot swapping, which requires a lot of effort. Moreover, when its shaft is pulled out, it is left and right.

It is not compatible with the shaft body of the regular height, so pay attention when changing the shaft

The keyboard body itself is light and thin, there is no sandwich cotton, and there is no bottom cotton. Open the upper case to find the pcb board and 2500 mAh battery

The weight of the whole machine is relatively light, one catty, it is very suitable for business trips, carry it with you, it can be placed on the notebook and covered with the original keyboard to enhance the feel

Comes with 2D stickers, official driver can set keys and control lights

The appearance and potential appearance are high, and the appearance is also very neutral. It takes into account the portability of the membrane keyboard and the feel of the mechanical keyboard. When I first started, I felt that the appearance was not so amazing, but when I thought it was an aluminum shell + transparent back cover, I became more and more excited. The more pleasing to the eye, change to a chocolate translucent keycap later